Skip to main content

AVF-6550 Firmware

  • Updated

This article contains installation instructions and firmware files for the Avocor AVF-6550 interactive display.

Firmware installation instructions

Things you'll need:

  • FAT32 Formatted USB Drive
  • Avocor AVF-6550 Remote Control

Checking your firmware version

Prior to installing firmware, you should check your current version in the display's OSD by pressing the Settings key on your Avocor remote control and navigating to the Information submenu.

mceclip0.png

Scaler installation

  1. Download the Scaler_AVF-6550_VXXX.bin onto your FAT32 formatted USB flash drive (click here for downloads).
  2. Rename Scaler_AVF-6550_VXXX.bin to merge.bin (see here for details).
  3. Plug the USB flash drive into the USB Service Port, located on the display's side I/O panel.2019-11-12_15h12_17.png
  4. Open the OSD via the menu button on your Avocor remote control.
  5. Navigate to Adv. Settings>Firmware Update USB.
  6. When prompted "Are you sure?" select Yes.
  7. After the install finishes and the display reboots, initiate a Restore Factory Default and then power cycle the unit via the A/C rocker switch near the power cable plug.

USB file name format

The image below shows how the renamed files should look in your USB directory.

mceclip0.png

 

Firmware and release notes

Click the version number of your desired firmware to download.

Release Date Scaler Ver. Notes
11/21/2019 V1.04
  • Added OPS Power State to OSD under Adv. Settings:
    • Follows display (default): OPS will shut off when display is powered down. 
    • Always on: OPS will remain powered on even when display is powered down.
  • Revised description for Wake Up From Sleep and added VGA as an option.
  • HDMI HDCP to OSD under Adv. Settings:
    • Enable All (default)
    • Disable HDMI 1
    • Disable HDMI 2
    • Disable HDMI 1 & 2
  • HDMI RGB Range: 
    • Default: 0~255
  • Changed Audio Source options:
    • Video Source (default, except for VGA)
    • Aux Input
    • USB
  • Added Game Mode under Adv. Settings (default: On).
  • Changed Software Update(USB) to Firmware Update.
  • Added the following RS232 commands:
    • Ability to Check for Input Signal (responses below):
      • 0 - Signal
      • 1 - No Signal
    • OPS Power State
      • 0 - Follows display
      • 1 - Always on
    • VOI & VOD: Increment & decrement volume by definable value.
    • Define HDMI HDCP settings
      • 0 - Enable All
      • 1 - Disable HDMI 1 & 2
      • 2 - Disable HDMI 1
      • 3 - Disable HDMI 2
-- V1.02
  • Added the ability to change the Home Source.
-- V1.01
  • When the display goes to sleep due to inactivity, the OPS will not power off.
-- V1.00
  • Initial release version.
Powered by Zendesk