Precaution
When installing or uninstalling an OPS module is a relatively simple process, but one that still needs a level of care and attention in order to keep the OPS module and the OPS slot on the display in working order, as improper installation may cause malfunction or even damage these components.
Please follow these instructions carefully when installing an Avocor OPS module into your display.
OPS Installation Step-by-Step
- Step 1: Power off the display with the A/C switch located near the A/C input.
- Step 2: Remove the OPS slot shield on the display input panel
- Step 3: Install the OPS module by carefully sliding it into the OPS slot as pictured below.
- NOTE: the "OPS ===>" imprint should be upside down and facing the back panel of the display. If there is no imprint, then the small square fan vent should be facing the same direction back panel.
- Step 4: Secure the OPS computer into the slot using the screws that were removed earlier
That's it! Your OPS should be ready to go. Just power on the display and press the power button on the OPS module to turn it on.
For uninstalling the OPS or swapping it between panels, please be sure to follow the same instructions and fully power down the panel via AC switch before you uninstall or swap OPS(s).
For servicing needs, please reach out to Avocor Support for assistance with servicing your Avocor OPS.