Precaution

Installing an OPS module is a relatively simple process, but one that still needs a level of care and attention in order to keep the OPS module and the OPS slot on the display in working order, as improper installation may cause malfunction or even damage these components.

Please follow these instructions carefully when installing an Avocor OPS module into your display.

OPS Installation Step-by-Step

Step 1: Remove the OPS slot shield on the display input panel

Step 2: Install the Avocor Zoom Ready OPS computer by carefully sliding it into the OPS slot as pictured below.
- NOTE: the "OPS ===>" imprint should be upside down and facing the back panel of the display. If there is no imprint, then the small square fan vent should be facing the same direction back panel.

Step 3: Secure the OPS computer into the slot using the screws that were removed earlier

That's it! Your OPS should be ready to go. Just hit the power button on the OPS module to turn it on.